Delta 36-070 Manuel d'instructions

INSTRUCTION MANUAL10" Power Miter Saw(Model 36-070)PART NO. 899880 (0012)Copyright © 2000 Delta MachineryESPAÑOL: PÁGINA 21To learn more about DE

10ADJUSTING BLADE PARALLEL TO TABLE OPENING1. DISCONNECT THE SAW FROM THE POWERSOURCE.2. Lower the cuttinghead and check to see if the sawblade (A) Fi

1111111. An ideal accessory for use with your miter saw is the36-221 Work Clamp, shown at (A) Fig. 24.2. Two holes (B) Fig. 25, are provided in the ba

121. Your miter saw has the capacity to cut standard 2 x4’s laying flat or on edge, at the 45 degree right and leftmiter angles as shown in Figs. 26 a

1313134. Cutting various sizes of plastic pipe is an easy jobwith the miter saw, as shown in Fig. 30.CUTTING ALUMINUMAluminum extrusions such as used

141. There are several methods that can be used to cutcrown mouldings on the miter saw. The method shownin Fig. 35, illustrates the contact surfaces (

15155. Fasten the filler blocks to the fence using woodscrews (A) through the two holes provided on eachfence half, as shown in Fig. 40. This enables

16CHANGING THE BLADEWARNING: USE ONLY CROSS-CUTTING SAWBLADES. WHEN USING CARBIDE TIPPED BLADES,MAKE SURE THEY HAVE A NEGATIVE HOOK ANGLE.DO NOT USE B

171717BRUSH INSPECTION AND REPLACEMENTCAUTION: BEFORE INSPECTING THE BRUSHES,DISCONNECT THE MACHINE FROM THE POWERSOURCE.Brush life varies. It depends

181818NOTES

191919NOTES

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are certainhazards in

2020Delta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta ma

The following are trademarks of PORTER-CABLEDELTA Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.):BAMMER®, INNOVATION THAT W

33ADDITIONAL SAFETY RULESFOR MITER SAWS1. USE ONLY CROSS-CUTTING SAW BLADES.WHEN USING CARBIDE-TIPPED BLADES, MAKESURE THEY HAVE A NEGATIVE HOOK ANGLE

44UNPACKING1. Remove the miter saw and all loose items from thecarton. IMPORTANT: DO NOT LIFT THE MITER SAWBY THE SWITCH HANDLE AS THIS MAY CAUSE MIS-

55ASSEMBLINGTABLE LOCK HANDLE1. Thread table lock handle (A) Fig. 5, into the thread-ed hole (B) of the arm bracket.ROTATING TABLE TO 90 DEGREE POSITI

6CONNECTING SAW TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12

777Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug

888STARTING AND STOPPING MACHINETo start the machine, depress switch trigger (A) Fig. 12.To stop the machine, release the switch trigger.This miter sa

999Fig. 16LOCKING CUTTINGHEAD IN THE DOWN POSITIONWhen transporting the miter saw, the cuttingheadshould always be locked in the down position. This c