Delta A15097 Manuel d'utilisateur télécharger pdf (Page 10)

ATTACHING MOTOR AND BLOWER

ASSEMBLY TO FRAME

1. Place motor assembly and base assembly on their

side.

2. Align the four holes, two shown at (C), on the top of

the side supports (A) Fig. 8, with the four holes in the

motor assembly (B).

3. Place a 5/16" lockwasher onto a 5/16-18x3/4" hex

head screw and insert the bolt thru the side support

and thread bolt into the tapped hole in the motor

assembly and tighten securely.

4. Repeat this process for the three remaining holes.

5. Fig. 9 shows the motor and blower assembly

attached to the side supports.

Fig. 8

SIDE SUPPORTS

1. Place the dust collector base (A) Fig. 5, in an upright

position as shown.

2. Align the two holes in the wider end of the side

support (B) Fig. 5 with the two holes (C) in the

base.

3. Insert a 5/16-18x3/4" hex head screw (A) Fig. 6 thru

each hole in the side support and base.

4. Place a 5/16" lockwasher onto the hex head screw.

5. Thread a 5/16-18 hex nut onto the hex head screw

and tighten securely.

6. Repeat this process for the remaining side support.

7. Fig. 7 shows both side supports (A) attached to the

base (B).

Fig. 5

Fig. 6

Fig. 7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

Delta A15097 Manuel d'utilisateur Page 10