Delta LA200 Manuel d'instructions télécharger pdf (Page 3)

ADDITIONAL SAFETY RULES FOR

WOOD LATHES

1. DO NOT OPERATE THIS MACHINE UNTIL it is assem-

bled and installed according to the instructions.

2. OBTAIN ADVICE from your supervisor, instructor, or

another qualified person if you are not familiar with the

operation of this machine.

3. FOLLOW ALL WIRING CODES and recommended

electrical connections.

4. ROUGH CUT THE WORKPIECE as close as possible to

the finished shape before installing it on the faceplate.

5. EXAMINE THE WORKPIECE FOR FLAWS and test glue

joints before mounting the workpiece on machine. DO

NOT mount a split workpiece or one containing a knot.

6. SECURELY FASTEN THE WORKPIECE to the faceplate

prior to faceplate turning. Use the appropriate size face-

plate to properly support the workpiece. Do not let the

screw fasteners interfere with the turning tool at the fin-

ished dimension of the workpiece.

7. NEVER DRIVE THE WORKPIECE into the drive center

while the drive center is in the headstock. Set the drive

center into the workpiece with a soft mallet prior to

installing it into the headstock.

8. SNUG THE TAILSTOCK CENTER against the work-

piece and lock it when turning between centers.

Lubricate the tailstock center if it is not a ball bearing

center.

9. PROPERLY ADJUST THE TOOL REST HEIGHT.

10. ADJUST THE TOOL REST so it is as close to the work-

piece as possible.

11. TIGHTEN ALL CLAMP LOCKING HANDLES before

operating.

12. ROTATE THE WORKPIECE BY HAND to check clear-

ance before turning the machine “ON”.

13. CLEAR THE LATHE BED OF ALL OBJECTS (tools,

scraps of wood, etc.) before turning the machine “ON”.

14. EXAMINE THE SET-UP CAREFULLY before turning the

machine “ON”.

15. STAND CLEAR, AND KEEP ALL OBSERVERS AND

PASSERSBY clear of rotating path of workpiece to

avoid injury from flying debris.

16. USE THE LOWEST SPEED when starting a new work-

piece. NEVER EXCEED recommended speeds.

17. NEVER ADJUST THE TOOL REST while the workpiece

is turning.

18. NEVER LOOSEN THE TAILSTOCK SPINDLE or the

tailstock while workpiece is turning.

19. MOVE THE CUTTING TOOL INTO THE WORKPIECE

SLOWLY, and cut small amounts when roughing.

20. REMOVE THE TOOL REST before sanding or polish-

ing.

21. NEVER PERFORM LAYOUT, assembly, or set-up work

on the table/work area when the machine is running.

22. TURN THE MACHINE “OFF” AND DISCONNECT

THE MACHINE from the power source before installing

or removing accessories, before adjusting or changing

set-ups, or when making repairs.

23. TURN THE MACHINE “OFF”, disconnect the machine

from the power source, and clean the table/work area

before leaving the machine. LOCK THE SWITCH IN

THE “OFF” POSITION to prevent unauthorized use.

24. ADDITIONAL INFORMATION regarding the safe and

proper operation of this machine is available from the

Power Tool Institute, 1300 Summer Avenue, Cleveland,

OH 44115-2851. Information is also available from the

National Safety Council, 1121 Spring Lake Drive,

Itasca, IL 60143-3201. Please refer to the American

National Standards Institute ANSI 01.1 Safety

Requirements for Woodworking Machines and the U.S.

Department of Labor OSHA 1910.213 Regulations.

SAVE THESE INSTRUCTIONS.

Refer to them often

and use them to instruct others

WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.

1 2 3 4 5 6 7 8 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Delta LA200 Manuel d'instructions Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Tours Delta LA200