Delta 14-070 Manuel d'instructions télécharger pdf (Page 6)

CLEANING

Remove the protective coating from the machined surfaces of the drill press and all loose items. This coating may be

removed with a soft cloth moistened with kerosene. DO NOT use acetone, gasoline, or lacquer thinner for this pur-

pose.

ASSEMBLY INSTRUCTIONS

1. Assemble the column (A) Fig. 3, to the base (B)

using the four screws, three of which are shown at (C).

2. Loosen set screw in ring (D) Fig. 3, and remove

ring (D) and raising rack (E).

3. Insert shaft of worm gear (F) Fig. 4, into hole (G)

from inside of table bracket (H).

Fig. 3

Fig. 4

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Pas de commentaire

Delta 14-070 Manuel d'instructions Page 6