Delta 33-891 Manuel d'utilisateur télécharger pdf (Page 7)

ASSEMBLY

Fig. 4A

ASSEMBLING

STEEL LEGS TO BASE

Carefully support the machine to the rear and brace the

frame so the machine is balanced. Attach the four steel

legs to each end of the base using sixteen 5/16-18x5/8"

carriage head screws (A) Fig. 4A and Fig. 4B, 5/16" flat

washers (B), 5/16" lockwashers (C) and 5/16" hex nuts

(D). Return saw to upright position.

Fig. 5

Fig. 6

ASSEMBLING OVERARM

ELEVATING HANDLE

1. Insert roll pin (A) Fig. 5, into the hole in elevating

shaft (B).

2. Line up the slots in elevating handle (C) Fig. 5, with

roll pin (A) and place handle on shaft (B) making certain

the roll pin is engaged in the slots.

3. Fasten elevating handle (C) Fig. 6, to shaft (B) with

a 1/4-20X1/2" hex head screw (D) and 1/4" flat washer

(E).

Fig. 4B

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Pas de commentaire

Delta 33-891 Manuel d'utilisateur Page 7