Delta RMC101 Manuel d'utilisateur télécharger pdf (Page 823)

100

101

Appendix C: Parameter Field Reference

C-53

Level of H Input

The Home Input status bit is set when the Home

(H) input is active. It is not latched.

For details on using this bit, see Homing a Quadrature Axis.

C.4.4 Coord. Limit

Default: 0

Range: -65536 to 65535 (Quadrature), -65536 to 0 (Stepper)

This parameter is available only on stepper, resolver, and quadrature axes. It defines the 16-bit

position unit range. For a complete discussion on the use of this parameter, read the topic that

applies to the transducers you are using:

• Scaling Servo Axes

• Scaling Stepper Axes

• Scaling Resolver Axes

What if it is displayed under RMCWin incorrectly?

The Coordinate Limit parameter may be displayed incorrectly on the RMCWin main screen in

some circumstances. The numbers are not necessarily incorrect (the module still functions

correctly), but they may not look right. This is because RMCWin assumes the Coordinate Limit

read from the RMC has a sign opposite of the scale for Quadrature (servo) axes until it is told

otherwise. To correct the problem, enter the correct value for the Coordinate Limit and save the

parameters to a file (on the File menu, click Save). Whenever you start RMCWin, read the

parameters from the file and the problem should be corrected.

C.4.5 Extend Limit

Default: Current position on power-up

Range: Valid 16-bit Position

The Extend Limit specifies the maximum requested position value that the RMC will allow as a

Command Value. (When the Scale is negative, this is the minimum value.) A Command Value

that exceeds this value will be set to the Extend Limit, and the Parameter Error bit in the Status

word will be set. The Extend Limit is given in Position Units.

Note: The Extend Limit must be changed when the Scale or Offset parameters are changed.

Extending is the direction that gives increasing Transducer Counts.

Note: On startup, the Extend Limit defaults to the current position of the axis, so new Extend

and Retract Limits must be issued followed by a ’r;P’ command before the axis will move, unless

different limits have been saved in the Flash.

1 2 ... 818 819 820 821 822 823 824 825 826 827 828 ... 950 951

Commentaires sur ces manuels

Pas de commentaire

Delta RMC101 Manuel d'utilisateur Page 823

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Delta RMC101