Delta RMC70 Manuel d'utilisateur télécharger pdf (Page 22)

RMC70 Startup Guide

20 Delta Computer Systems, Inc.

Step 10: Scale and Offset

The Scale and Offset parameters convert the Counts, Volts or Current

from the transducer into meaningful measurement units, such as

inches, millimeters, pounds, Newtons, etc. RMCTools provides

Scale/Offset wizards to help you calculate these parameters.

Before starting, determine approximately what the positions should

be at either end of travel. This will help you verify later that you

performed the Scaling and Offset procedure correctly.

To set the Scale and Offset:

1. Go to the Axes Parameters

pane, Setup tab, Tools and

Wizards section.

2. Click Launch in the desired

axis.

3. In the wizard, follow the directions. For help, press the Help

button.

4. After completing the wizard, click the Download button to

apply the changes to the RMC.

5. Remember to save your project and update Flash.

Tip: If the wizard does not work for your system, you can manually

determine the Scale and Offset parameters. See the Scaling topic

in the RMCTools help for details.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Pas de commentaire

Delta RMC70 Manuel d'utilisateur Page 22