Delta BS150LS Manuel d'instructions télécharger pdf (Page 10)

7. Fig. 14 shows the disassembled table tilt pinion knob

(N) , spring (O), and special screw (P), removed in

STEP 1.

8. Re-assemble the table tilt pinion knob (N) Fig.

15, on the back of saw so that the teeth on the

pinion knob (N) engage the teeth on the trunnion

(R). Fasten in place with the special screw (P) and

spring using the 4mm wrench provided.

4. Re-assemble the locking lever stud (G) Fig. 12

through the trunnion slot (L) and tighten with the

table locking lever handle (see inset).

5. Fig. 13 shows the table locking lever disassembled

(removed in STEP 1). Item (B) is a M10 flat washer,

(G) stud, (A) Locking Lever, (E) spring, (D) shoulder

screw, and (C) 4mm hex wrench.

6. Re-assemble the screw (D) Fig.13A and tighten using

4mm hex wrench provided.

Fig.14

Fig.15

Fig. 13A

Fig. 12

Fig. 13

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 71 72

Pas de commentaire

Delta BS150LS Manuel d'instructions Page 10