Delta 37-360 Manuel d'instructions télécharger pdf (Page 12)

Fig. 16

Fig. 17

THREE PHASE INSTALLATION

If the motor on your machine is wired for 200, 230 or 460 Volts, Three Phase, proceed as follows when connecting

your machine to an electrical power system.

1. Remove screw (A) Fig. 15, and terminal strip cover

(B).

2. Remove plastic covering (C) Fig. 16, that snaps into

terminal strip.

3. Bring three phase power line through access hole in

bottom of terminal strip box and connect the three power

lines to terminals (D) Fig. 17, and the green ground wire

to ground screw (E).

Fig. 15

The rotation of the cutterhead must be in a

clockwise direction when viewed from the

left side of the machine; that is, the knives

must be rotating toward the infeed table

from the top. If the cutterhead rotation is

incorrect, disconnect the machine from the

power source and interchange any two of

the three incoming power lines connected to

terminals (D) Fig. 17.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

Delta 37-360 Manuel d'instructions Page 12