Delta 36-841 Manuel d'utilisateur télécharger pdf (Page 11)

6. Using a wrench to hold the hex nut (J) Fig. 16, tight-

en rod (G) Fig. 17, with a small screwdriver (K) or similar

device through the hole in the end of the rod as shown.

7. Assemble lower bracket (L) Fig. 18, to rod (G) and

loosely tighten with two one-inch long hex head screws

(S) and lockwashers from underneath bracket (L).

8. Assemble upper splitter bracket (M) Fig. 19, to lower

bracket (L) using one-inch long hex head screw (N) with

lockwasher and flat washer. NOTE: Do not tighten screw

(N) at this time.

9. Insert the front end of splitter (P) Fig. 20, inside the

splitter mounting bracket behind splitter fastener plate

and screw (C). Push splitter down as far as possible,

making certain the bottom edge of splitter (P) is parallel

with the table surface. Tighten screw (C). Fasten splitter

and blade guard assembly (P) Fig. 21, to bracket (M)

using one-inch long screw (V) and flat washer.

10. IMPORTANT: The splitter (P) Fig. 22, features a notch

(W) cut into the top edge. Simply raise the front of the

clear blade guard (P) Fig. 22, until the rear edge of the

guard slips into notch (W) of the splitter. This notch

enables the blade guard to stay in the raised position and

makes changing blades easier.

Fig. 17 Fig. 18

Fig. 19

Fig. 20

Fig. 21

Fig. 22

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Pas de commentaire

Delta 36-841 Manuel d'utilisateur Page 11