Delta 50-860 Spécifications télécharger pdf (Page 7)

Fig. 5

Fig. 6

MOUNTING THE AIR CLEANER TO THE CEILING O R

OVERHEAD SUPPORT

W ARNING: THIS TO O L WEIGHS APPROXIMATELY

50 POUNDS. MAKE CERTAIN THE UNIT IS SECURE-

LY SUPPORTED WHENMOUNTING TO A CEILING

O R OVERHEAD SUPPORT.

1. Locate (4) one inch eye-bolt s, and (4) 1/4-20 flange

nut s supplied with the unit.

2. Remove four screws, one of which is shown at (C)

Fig. 5, from the top of air cleaner (D).

3. Thread one flange nut (E) Fig. 5, approximately half-

way onto each eye-bolt (F) supplied, as shown.

4. Thread each eye-bolt (F) Fig. 5, into each of the four

holes where screws (C) were removed in STEP 2.

5. Fig. 6, illustrates the four eye-bolt s (F) att ached to

top of air cleaner . NOTE: To adjust the height of the air

cleaner, loosen flange nut s (E) and rot ate eye-bolt s as

necessary.Make certain the flange nut s (E) Fig. 6, are

tightened down against the surface of the air cleaner

after height adjustments are made.

When suspending the air cleaner from the ceiling or

other overhead support, make cert ain the supporting

hardware (not supplied) is securely anchored into a

wooden supporting structure as shown in Fig. 7.

W ARNING: NEVER SECURE MOUNTING HARDWARE

TO D RY WALL, DROP CEILING TILE/FRAME, OR NON-

STRUCTURAL MEMBERS.

W ARNING: Keep a minimum of seven feet between bottom of air cleaner and the floor surface.

D O N O T use rope, cable or power cord to suspend the unit from the ceiling. We recommend that a chain should

be used and rated for a minimum of a 100 lb. working load to firmly support the air cleaner. IMPORTA N T:When

determining a location to mount the unit, the air cleaner will operate more efficiently when the air flow is unre -

stricted. Do not locate the unit in a corner or near any heating or cooling vents.

Fig. 7

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Delta 50-860 Spécifications Page 7