Delta ShopMaster SM300 Manuel d'instructions télécharger pdf (Page 9)

ASSEMBLING

TABLE INSERT

The table insert (A) is assembled in the table, as shown

in Fig. 11.

Fig. 11

FASTENING

ROUTER/SHAPER

TO SUPPORTING

SURFACE

IF DURING OPERATION THERE IS ANY TENDENCY

FOR THE ROUTER/SHAPER TO TIP OVER, SLIDE OR

WALK ON THE SUPPORTING SURFACE, THE

ROUTER/SHAPER SHOULD BE SECURED TO THE

SUPPORTING SURFACE. REMOVE THE FOUR

RUBBER FEET ATTACHED TO THE ROUTER/SHAPER,

AND FASTENING THE MACHINE TO THE SUPPORTING

SURFACE WITH FASTENERS (not supplied).

IF YOU PURCHASED THE ACCESSORY STAND, THE

FOUR PLASTIC FEET, SUPPLIED WITH THE STAND,

FEATURE HOLES WHICH ALLOW THE STAND TO BE

SECURED TO A SUPPORTING SURFACE WITH

FASTENERS (not supplied).

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING

ROUTER/SHAPER

The on/off switch (A) Fig. 14, is located on the front of the

Router/Shaper cabinet. To turn the machine “ON,” move

the switch (A), up to the “ON” position. To turn the

machine “OFF,” move the switch (A), down to the “OFF”

position.

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use. This can be done by grasping the

switch toggle (B) Fig. 15, and pulling it out of the switch

as shown. With the switch toggle (B) removed, the switch

will not operate. However, should the switch toggle be

removed while the machine is running, it can be turned

“OFF” once, but cannot be restarted without inserting

the switch toggle (B).

Fig. 14

Fig. 15

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Commentaires sur ces manuels

Pas de commentaire

Delta ShopMaster SM300 Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Delta ShopMaster SM300