Delta 36-978 Manuel d'instructions télécharger pdf (Page 11)

MOBILE BASE AND STAND ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT MACHINE TO POWER SOURCE UNTIL MACHINE IS

COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE INSTRUCTION MANUAL.

The mobile base and stand should be put

together upside down to ease assembly. To

assemble the mobile base and stand:

FRONT AND SIDE PANELS

1. Insert a

/16-18 x

/8" Carriage Head

Screw (A) Fig. 5 through the leg (B) and

then corresponding hole in the panel

sure the squares of hex screw align

with the flat sides of the hole opening.

2. Thread a

/16-18 Serrated Hex Nut (D)

around screw and finger tighten panel

to leg, as shown in Fig. 6. Make sure the

serrated face of the hex nut is against

the panel. NOTE: HAND TIGHTEN

ONLY FOR LATER ADJUSTMENTS.

3. Fig. 7 shows all four legs attached to

the front and side panels. NOTE: Make

sure short panels are opposite each

other and that long panels are opposite

each other.

SHORT AND LONG LEG SUPPORTS

4. Attach long side leg supports (E) Fig.

8 and short side leg supports to the

legs using

/16-18 x

/8" Carriage Head

Screws and

/16-18 Serrated Hex Nuts.

Insert the screw through the leg first

and then the support. NOTE: Be

sure the holes (J) Fig. 9 in all side

supports will be aligned as shown after

assembly.

5. Thread hex nut onto screw and finger

tighten only. At this time, only assemble

eight screws and eight nuts into holes

- two of which are shown at (F) Fig. 9.

Make sure these are the holes which

will be on the bottom (after saw is

turned right side up).

CORNER BRACKETS

6. Take corner bracket (G) Fig. 10 with

the closed end and align holes (H) with

holes (I) in the leg supports. NOTE:

MAKE SURE THE CLOSED-END

BRACKETS (G) ARE ATTACHED TO

THE LONG LEG SUPPORT WHICH

HAS THE THREE HOLES IN THE

MIDDLE, AS SHOWN IN FIG.13.

It may be necessary to take a soft

hammer (or a regular hammer and

block of wood) to tap in the corner

bracket to align holes, as in Fig. 11.

7. Once aligned, attach the corner

bracket to the leg supports using the

/16-18 x

/8" Carriage Head Screws and

/16-18 Serrated Hex Nuts. Insert screw

through support and then the corner

bracket at (K) Fig. 12. Thread hex nut

onto screw and tighten.

8. Then attach leg to corner bracket

using the longer

/16-18 x

/4" Carriage

Head Screws and

/16-18 Serrated Hex

Nuts in two holes, one of which is at (L)

Fig. 12.

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Fig. 12

Fig. 13

Fig. 14

Downloaded from www.Manualslib.com manuals search engine

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Delta 36-978 Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Delta 36-978