Delta 31-750 Manuel d'utilisateur télécharger pdf (Page 6)

Fig. 4

Fig. 5

Fig. 7

Fig. 6

HOOKANDLOOP

If you are using the hook and loop backed abrasive disc,

simply position hook and loop abrasive disc (A) Fig. 4,

directly onto disc plate p ad (B).

ASSEMBLING ABRASIVE

DISCS TO DISC PLAT E

IMPORTANT:MAKECERTAIN THE MACHINE IS DIS-

CONNECTED FROMTHEPOWERSOURCE.

There are two types of 9 abrasive discs available for

the sander: hook and loop, and adhesive-backed abra -

sive discs.

PRESSURE SENSITIVE ADHESIVE (PSA)

1. IMPORTANT:If you are using the pressure sensitive

adhesive-backed abrasive disc, you must first apply tran -

sition p ad (C) Fig. 5, to disc plate p ad (B).

2. Remove backing (D) Fig. 6, from abrasive disc (E)

and press the disc onto transition p ad (C).

ADJUSTING TABLE

IMPORTANT:Before operating the sander, the t able

surface must be positioned so it is slightly lower than the

sanding disc.

1. Place a straight edge (A) Fig. 7, on abrasive disc (B)

and check to see if the disc is slightly higher than the

table surface (C). NOTE: Check the t able height directly

over two adjustment screws (D) Fig. 7, and again over

screws (E).

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Delta 31-750 Manuel d'utilisateur Page 6