Delta 31-750 Manuel d'utilisateur télécharger pdf (Page 9)

CONNECTING SANDER TO POWERSOURCE

POWERCONNECTIONS

A sep arate electrical circuit should be used for your tools. This circuit should not be less

than #12 wire and should be protected with a 20 Amp fuse. Have a certified electrician

replace or rep air a worn cord immediately. Before connecting the motor to a power line,

make sure the switch is in the OFF position and be sure that the electric current is of

the same characteristics as st amped on the motor nameplate. Running on low volt age

will damage the motor.

W ARNING: DO NOT EXPOSE THE TO O L TO RAIN OR OPERATE THE TO O L IN

DAMPLOCATIONS.

M O TOR SPECIFICATIONS

Y our sander is wired for 1 10-120 volt, 60 Hz alternating current. Before connecting the

sander to the power source, make sure the switch is in the OFF position. The 3600

RPM motor provides 3600 oscillations per minute.

FASTENING SANDER TO A SUPPORTING SURFACE

If during operation there is any tendency for the sander to tip over , slide or walk, the

sander must be secured to the supporting surface using the four holes in the base of

the machine. If you purchased the accessory st and, the four plastic feet supplied with

the st and feature holes which allow easy mounting of the st and to a supporting surface.

Fig. 17

ACCESSORY 31-752 DISC HOLDER

An accessory abrasive disc holder (A) Fig. 16, is available to conveniently store extra

abrasive discs. The disc holder (A) slides neatly into the pocket of the sander as shown

in Fig. 17.

Fig. 16

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Delta 31-750 Manuel d'utilisateur Page 9