Delta CL180BN Manuel d'instructions télécharger pdf (Page 12)

INSTALLING OR REMOVING BATTERY PACK

Always set the trigger

switch to the locked OFF position

when installing or removing the

battery pack.

TO INSTALL BATTERY PACK: Align

rails (A) Fig. 4, on battery pack with

slots on tool and push battery pack

onto tool until it locks in place.

TO REMOVE BATTERY PACK:

Depress the battery release button (B)

Fig. 4, and pull battery pack out of

tool.

NOTE: This tool is shipped completely assembled. No assembly

time or tools are required.

LOADING FASTENERS

REMOVE BATTERY

PACK. ONLY USE APPROVED DELTA

FASTENERS.

1. Pull down on the nail pusher (A)

Fig. 5, until it locks in the open

position as shown in Fig. 6.

2. Insert a strip of approved

fasteners, (B) Fig. 7. Orient

fasteners with points down, and

in contact with the bottom of the

magazine.

3. Pull nail pusher (A) Fig. 8,

completely to the rear, rotate

lever to the right and allow nail

pusher to slowly slide forward to

contact nails.

Fig. 4

ASSEMBLY

Fig. 6

Fig. 8

Fig. 7

Fig. 5

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Delta CL180BN Manuel d'instructions Page 12