Delta SA180 Instructions d'exploitation télécharger pdf (Page 12)

Fig. 13

Fig. 14

Fig. 15

Fig. 16

ASSEMBLING SANDING DISC TABLE

1. Disconnect machine from power

source.

2. Two clamp handles are supplied with your machine,

one for the belt sander table and one for the

disc sander table. Disassemble both handles by

unscrewing and removing screw (A), spring (B), and

handle (C) from locking stud (D), as shown in Fig. 13.

3. Position the disc table (E) Fig. 14, on the disc base

casting, making sure the key (F) on the table bracket

is engaged with the keyway (G) on the base casting.

4. Place a 10mm flat washer (J) Fig. 15, onto locking

stud (H) Fig. 15, and thread stud into base casting

to hold table assembly (E) in place as shown.

5. Place handle (C) Fig. 15, onto locking stud (H) and

fasten with screw (A) and spring (B).

6. Fig. 16, illustrates the locking handle (C) assembled.

NOTE: The locking handle (C) is spring-loaded

and can be repositioned by pulling out the handle

and repositioning it on the serrated stud located

underneath the handle.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Pas de commentaire

Delta SA180 Instructions d'exploitation Page 12