Delta JT160 Manuel d'instructions télécharger pdf (Page 13)

DEPTH OF CUT ADJUSTMENT

The jointer can be set to cut any depth from a very thin

shaving to 1/8" deep. A dual English/Metric scale (A)

Fig. 24, and pointer (B) are provided to indicate the depth

of cut. To adjust for depth of cut, loosen lock knob (C)

and turn adjusting knob (D) clockwise to lower and coun-

ter clock wise to raise the infeed table. Raising the infeed

table decreases the depth of cut, while lowering it will

increase the depth. After the infeed table is at the desired

setting, tighten lock knob (C).

NOTE: For best results, final positioning of the infeed

table should always be made from the bottom to the up

position.

FENCE ADJUSTMENTS

The fence can be moved across the table and can be

tilted up to 45 degrees, as follows:

1. To move the fence across the table, loosen lock lever

(A) Fig. 25, slide the fence to the desired position on

the table and tighten lever (A).

NOTE: Lock lever (A) is spring loaded and can be

repositioned by pulling up on the lever and repositioning

it on the nut located underneath the lever.

2. To tilt the fence, loosen lever (B) Fig. 25, and tilt the

fence to the desired angle. Then tighten lever (B).

NOTE: Lever (B) is spring loaded and can be repositioned

by pulling out on the lever and repositioning it on the nut

located un der neath the lever.

3. The fence features adjustable positive stops at the

most used fence positions of 90 degrees and 45

degrees to the right. To check and adjust the positive

stops, proceed as follows:

4. Place a square (C) Fig. 26, on the table with one end

of the square against the fence as shown. Adjust the

fence until it is exactly 90 degrees to the table.

5. Using supplied hex wrench (No. 10, Fig. 4A), turn set

screw (D) Fig. 27 until it contacts stop (E).

Fig. 24

Fig. 25

Fig. 26

Fig. 27

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Pas de commentaire

Delta JT160 Manuel d'instructions Page 13