Delta JT160 Manuel d'instructions télécharger pdf (Page 10)

Fig. 5A

THE JOINTER IS EXTREMELY HEAVY. HAVE TWO OR MORE PEOPLE HELP LIFT AND MOVE

MACHINE AROUND DURING ASSEMBLY.

Fig. 4B

Infeed Table

Outfeed Table

JOINTER TO STAND

NOTE: THE MOTOR IS BOLTED TO THE TOP OF THE

STAND AND MUST BE ATTACHED TO THE MOTOR

MOUNTING BRACKETS.

1. Turn stand upside down as shown in Fig. 4B.

2. Remove the six screws (C) Fig. 4A. Then remove

back panel (E) from the stand.

3. Remove the four bolts that attach the motor (A) Fig

4B to the stand. NOTE: SAVE THESE BOLTS AS

THEY WILL BE USED TO ATTACH THE MOTOR

TO THE MOUNTING BRACKETS.

4. Align the holes in the motor mounting plate with the

four holes (B) Fig. 4B in the two motor mounting

brackets (C). Attach the motor to the motor

mounting brackets with the hardware that was

removed in STEP 2. NOTE: MAKE SURE THAT

MOTOR SHAFT (D) FIG 4C IS FACING OUT OF

THE OPENING IN THE MOTOR CABINET AS

SHOWN.

5. Turn the stand over so that it is resting on its base

as shown in Fig. 4C.

6. Line up the eight holes (B) Fig. 5A, on the top of the

stand with the eight threaded holes on the bottom of

the jointer base (shown in Fig. 5) and fasten the

jointer to the stand using the eight M8x1.25x25mm

socket head cap screws and M8.1 lockwashers

supplied.

NOTE: THE OUTFEED END OF THE JOINTER FIG. 5

MUST BE POINTING TOWARD THE END OF THE

STAND WITH DUST CHUTE (D) FIG. 5A.

Fig. 4C

Fig. 4A

Fig. 5

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

Delta JT160 Manuel d'instructions Page 10