Delta ts200ls Manuel d'instructions télécharger pdf (Page 13)

Fig. 18

Fig. 15

Fig. 17Fig. 16

NOTE: Before tightening the wing nut (M) Fig. 15,

make certain a gap of at least 1/8" is between the

bottom edge of the splitter (N) and the top surface of

the table (P) and that the protrusions (K) are inside

the slot of the splitter assembly (H).

8. Use a straight edge to see if the splitter (H)

Fig. 16 is aligned with the saw blade (R). If an

adjustment is necessary, the splitter (H) can be

moved left or right and rotated.

9. When the splitter is properly aligned with the saw

blade, tighten the screws (C) and (G) Fig. 17.

MITER GAUGE

The miter gauge is shipped assembled and is supplied

with a T-slot bar (A) Fig. 18 that is inserted into either one

of the two T-slotted miter gauge grooves (B) located in

the table top. The T-slot prevents the miter gauge from

falling when it is extended beyond the front of the table

when cross-cutting extra wide workpieces.

ATTACHING MITER GAUGE HOLDER

DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 19

Fig. 20

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Pas de commentaire

Delta ts200ls Manuel d'instructions Page 13