Delta 20-330 Manuel d'instructions télécharger pdf (Page 14)

14 - English

ADJUSTING BLADE GUIDE BRACKETS

Disconnect machine from power source.

The left and right blade guide brackets (A) and (B) Fig.

22, are adjustable by loosening the two lock knobs (C)

and sliding the brackets to accommodate the width of

the work piece. The guide brackets (A) and (B) should

be set as close as possible to the workpiece, without

interfering or touching the workpiece, or contacting the

table. Once the adjustment is made, tighten the lock

knobs (C).

Fig. 22

ADJUSTING FEED RATE

Disconnect machine from power source.

The feed rate of the saw arm can be adjusted by turning

the control arm (A) Fig. 23, counterclockwise to increase

or clockwise to decrease the feed rate. Do not turn the

control arm more than one turn at a time. Excessive

feed pressure can break or stall the blade. Insufficient

feed pressure dulls the blade rapidly.

Fig. 23

OPERATING AND

ADJUSTING THE VISE

Disconnect machine from power source.

The workpiece (A) is placed between the vise jaws with

the required amount to be cut-off extending out past

the blade, as shown in Fig. 24. To tighten the workpiece

in the vise, turn handwheel (B).

The vise can be adjusted to cut any angle from 0

degrees to 45 degrees by loosening the two screws

desired angle. A scale (E) is positioned on the rear of

the table to give the proper cutting angle. lt may also be

necessary when angle cutting to move the left vise jaw

(F) to the rear to clear the blade guide bracket.

Fig. 24

Fig. 25

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Pas de commentaire

Delta 20-330 Manuel d'instructions Page 14